E.g. for handling small ferromagnetic workpieces
- single-acting magnetic gripper
- end position can be monitored
- contour pieces for centering can simply be screwed on
- magnetic gripper is depressurized in the holding position
- if compressed air is applied, the held workpiece is braced
- thread on the head (M20x1.5) allows easy attachment of individual contours
- maximum air pressure is 6 bar, use dry and filtered air only
- The information given on the adhesive force was determined by pulling the magnet vertically off a 20 mm thick, flat ground steel plate St37 at room temperature. A deviation of up to -10% compared to the specified value is possible in exceptional cases. In general, however, this value is exceeded.
Active principle: | single-acting |
---|---|
Cable length: | - |
Coating: | - |
Connection: | - |
Connection thread: | M17x1 |
Contact: | - |
Hose connection thread: | G1/8″ |
Integrated magnet: | yes |
Material: | Aluminium |
Monitoring: | optional |
Poles: | - |
Self-locking: | no |
Sensor type: | - |
Signal output: | - |
Spring: | - |
Weight: | 70 g |
Downloads and 3D-data are only available to logged in users.